I did a netstat to look for the connection when I tried to connect and it didn't show anything. TX packets:1876 errors:0 dropped:0 overruns:0 carrier:0 RX packets:1876 errors:0 dropped:0 overruns:0 frame:0 If ping is not successful, consider these causes: No connected route peer or no route at all: show ip route peerIPaddress can be used. TX packets:11949 errors:0 dropped:0 overruns:0 carrier:0 If a ping test is performed without specific loopback as the source interface, the outgoing physical interface IP address is used as the packet’s source IP address instead of the router’s loopback IP address. RX packets:42002 errors:0 dropped:22 overruns:0 frame:0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 I tried 8.8.8.8, and another device that has ICMP enabled, and still get request timed out. Nameserver here is the output of ifconfig eth0 Link encap:Ethernet HWaddr 00:16:3c:a0:dc:a5 I have a windows 10 laptop that cannot ping anything except for the loopback address. Here is the output for the NS settings: cat /etc/nf The VPS maintains its not on their end even though I haven't changed anything applicable. Here are the network configurations: Windows Home WiFi adapter: IP and DNS: Auto (192.168.1.X) Loopback adapter: IP: 192.168.11.1. I made a loopback network adapter on my Windows 10 Home. I VMware and running some virtual machines on it (Windows 7 and Windows 10 ENT). Its no longer slugsh but now I’m dealing with a very confusing addressing issue.I have a ubuntu 14.04 server and for some reason the first(or two) time(s) I connect to telnet, ssh, or ping from the server to say. I am using Windows 10 Home with Kaspersky Total Security. I performed the restore becuase I noticed the device was a bit slugsh and rebooting it didn’t work. And it all started after that system only factory restore. If i redefine the static addres it will move itself to 10.0.0.3 but like a day later sometime even hours later it always reverts back to 10.0.0.102? So what the **bleep** is going on? I know 169 addresses are only assigned if theres a problem but I’m completely lost. I can fully accsses the device using 10.0.0.102. 1 - start to perform action 2 - if the net is down (or goes down) the action will fail. If the network is down your action will fail just as rapidly as a ping, etc. NetBIOS Remote Machine Name Table Name Type Status 1 - check, and it is OK 2 - start to perform action 3 - network goes down 4 - action fails 5 - lot of good your check did. ? (10.0.0.3) at (incomplete) on en0 ifscope Ping: cannot resolve Cloud9: Unknown hostĪgustins-MacBook-Pro:~ aescoto$ ping 10.0.0.3Īgustins-MacBook-Pro:~ aescoto$ ping 10.0.0.102 CLOUD9:/etc/network# cat interfaces Configure LoopbackĪgustins-MacBook-Pro:~ aescoto$ ping Cloud9 For any MS-DOS or Windows version with a TCP/IP client, PING can be used to delay execution for a number of seconds.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |